Question 1 of 6

Which of the waveforms shown below will appear on the scope when the detached BNC connector is attached to the output of the signal generator? Hint: For this question focus on the amplitude and volt per division dials as well as waveform shape.

	Waveform 1
	Waveform 2
	Waveform 3
	Waveform 4
		Next Question

Waveform 1	Waveform 2
Waveform 3	Waveform 4

Question 2 of 6

Which of the waveforms shown below will appear on the scope when the detached BNC connector is attached to the output of the signal generator? Hint: For this question focus on trigger options (edge type and level).

	Waveform 1
	Waveform 2
	Waveform 3
	Waveform 4
		Next Question

Waveform 1	Waveform 2
Waveform 3	Waveform 4

Question 3 of 6

Which of the waveforms shown below will appear on the scope when the detached BNC connector is attached to the output of the signal generator? Hint: For this question focus on the frequency and time per division dials.

	Waveform 1
	Waveform 2
	Waveform 3
	Waveform 4
		Next Question

Waveform 1	Waveform 2
Waveform 3	Waveform 4

Question 4 of 6

The scope shown is attached to a signal generator via the BNC cable. Determine the frequency of the waveform shown.

	6 Hz
	100 Hz
	8 Hz
	2 Hz
		Next Question

Question 5 of 6

The scope shown is attached to a signal generator via the BNC cable. Determine the DC offset associated with the waveform shown.

	-3.25 V
	-6.5 V
	-0.25 V
	-1.5 V
		Next Question

Question 6 of 6

The scope shown is attached to a signal generator via the BNC cable. Determine the peak to peak amplitude of the waveform shown.

	8 V
	6 V
	10 V
	2 V
		Submit and Finish Quiz